![]() History eMotorWerks Modular Mechanical Conversion System eMotorWerks was acquired by Enel through its EnerNOC, and is part of the Enel X group. eMotorWerks was founded in 2010 by Val Miftakhov, who was also its CEO until it merged with Enel X. If everything went well, your JuiceBox App dial should say 'STANDBY' on the bottom.Electric vehicle Charging stations, Demand responseĮMotorWerks, an Enel Group Company, is an electric vehicle infrastructure company, based in San Carlos, California. Tap 'done' and you should see your JuiceNet unit data on the screen.Select your unit, and create your password. A list of all JuiceBox units active on your network will appear - your JuiceBox, given it is associated with your network and has been active for at least 2 minutes, will appear there. Once installed, open your app and select “Add JuiceBox”. Make sure your device is connected to your WiFi network, as configured on the JuiceBox.Android app is available on the Google Play store, and can be found by searching “EV JuiceBox”.The iOS app is available in the Apple store as "'JuiceNet - Smart EV Charging'".Pair your Clipper Creek with JuiceBox Smartphone App: After ~3 minutes, WiFi setup will time out and will start transmitting data again. The charger will charge your car normally - just the first couple of minutes of data will be missing. ![]() During this time, no data will be transmitted to our servers. Note that after every power-cycle (unplugging from the AC outlet), the charger will go into the WiFi setup mode for up to 3 minutes.If you still don't see any JuiceBox listed under your router after ~5 minutes, ensure your PC is connected to the same network JuiceBox is connected to, or try repeating the pairing process (same steps as above). If you see your new JuiceBox, congratulations - it's alive! If you don't see it yet, you might need to wait for just a bit more - it takes ~3 minutes from power-up for JuiceBox to start sending data. Once logged in, click on a 'Add Juicebox' link and see if the system reports any JuiceBox IDs behind the same router.In your browser, navigate to the JuiceBox Dashboard at and login / register as needed.Typically, this will happen automatically within 15 seconds of completing setup. Reconnect your PC/phone to your home WiFi (same as your ClipperCreek unit is now connected to).It should state “Success! Your network password is correct”. Your network password will be verified, and it should connect to your home WiFi network. Select your home WiFi network and enter your network password.In a few seconds, you should see a list of WiFi networks your JuiceNet device has detected around itself. Using 'GoElectric' (no quotes) as the password, connect your PC / phone to the JuiceBox. On your PC / smartphone, find 'JuiceBox-#' WiFi network.If your ClipperCreek charger was powered on for more than 30 seconds, power-cycle it (unplug, wait for 5-10 seconds, plug back in).Connect your ClipperCreek unit to the Internet :įor step by step video instructions click here: For all charging fundamentals (such as mounting and installation, basic usage, safety, troubleshooting, etc.), please refer to the ClipperCreek manual. This guide is made to assist you in using the intelligence features of your JuiceNet EVSE (EV charging station).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |